DANA
Industrial Drive Shafts Catalogue
| Drive Shafts | |
|
|
| Special designs of cardan shafts and additional equipment | |||
| tt back to Table of contents | |||
| Series | Design features | Preferred application | |
| 587
* 190 Super short designs
|
Torque range TCS from 23 to 93 kNm Flange diameter from 275 to 405 mm |
 Closed bearing yokes (587) Split bearing yokes (190) Joints and lenght compensation
regreasable operating angle up to 15° |
Railway vehicles Rolling mill plants Marine drives Calender drives Paper machines General machinery construction plants Technical Data |
| 292 Gear shafts
|
Torque range TCS from 57 to 1053 kNm Flange diameter from 225/315 to 550/710 mm |
Shorter designs with
large length compensation Length compensation
through the joint High torque capacity with
small connection dimensions Split bearing yokes with
toothed bearing cap Bearings with labyrinth seals Operating angle up to 10°/7,5° |
Rolling mill plants |
| Journal
cross assemblies
|
Series 687,587
- Journal cross with low
notch factor
- Thrust washer
- Greasable sealing system Series 390,392,498,587
- Journal cross with low
notch factor
- Optimized roller bearing
- Greasable multiple sealing |
Technical Data | |
| Hirth-serration
|
Outside diameter from 225 to 1200 mm Number of teeth 48 to 180 |
High transmission capacity Form locking Self-centring |
Technical Data |
| Klingelnberg-serration
|
Outside diameter from 95 to 535 mm Number of teeth 16 to 96 |
High transmission capacity Form locking Self-centring |
Technical Data |
| Companion
flanges
|
Outside diameter from 100 mm onward |
Connection and features to
customer specification |
Technical Data |
| 330
* 230 Quick release couplings
|
Outside diameter from 100 to 435 mm |
Series elements of
cardan shafts Quick to release or to
close by operating a
single spindle |
Rolling mill plants Test rigs General machinery construction plants Technical Data |
| tt back to Table of contents | |||
| Email : info@landmark-autoparts.com | Websites |
|
